Will my filament spool fit?

Measure the spool you already have. The 1 kg on the label tells you the weight of filament, and spool dimensions vary even within the same brand.
Take two measurements
- Diameter. Lay the spool flat and measure straight across the widest flange through the centre. The maximum is 20 cm (200 mm).
- Width. Stand the spool on edge and measure across the outer faces, including any protruding hub or lip. The maximum is 8 cm (80 mm).
If either measurement is over the limit, choose a larger container. If your spool is right on the limit, measure again in a couple of places and check any adapters or clips you plan to leave attached. Email us the dimensions if you are unsure.
Check the centre if you’re printing a hub
The included centre-spool hub is optional and fits inside the spool opening. Measure that opening separately and check the printed part against your spool before printing a full batch. You can also use the printable desiccant wrap around the spool.
The closed container measures 22 cm across × 8 cm deep. Use those outside dimensions to plan the shelf.
Ready to set up your shelf?
Choose a container pack with free tracked UK delivery.